KENT Pearl Mineral RO Instruction Handbook For Installation, Operation And Maintenance

Contents

KENT Pearl Mineral RO Instruction Handbook For Installation, Operation And Maintenance Manual pdf 7 page image

5 6n nn nnThe purifier automatically shuts off when the The purifier automatically restarts when water levelstorage tank is full drops below the maximumThe purifier automatically flushes & cleans the RO The purifier does not allow any water rejection inmembrane on periodic intervals absence of electricity / when tank is fullThe purifier does not start when inlet water supply2pressure falls below 0.3 kg/cmAutomatic OperationFilter Change Alarm*TMKENT Pearl Mineral RO has an in-built feature that sounds an audible alarm to indicate replacementtime for filters. This alarm will be audible afterThe Filter Change Alarm will sound as following:4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of use.In case such an alarm is audible, please call the service technician and request him to change the filters of thepurifier. However, if the filters are not changed within the next 60 hours of operation, the purifier will stopfunctioning to ensure purity and hygiene. The following alarm will be audible after 60 Hrs.A continuous beep for an infinite time.In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replacethe filters. In such a circumstance, the purifier will not function unless the filters are changed.700 hrs of use since the last filter change (or since thetime of installation).TMKENT Pearl Mineral RO has an in-built feature that sounds an audible alarm if the UV lamp malfunctions.This feature is provided to ensure purer water. This UV Fail Alarm will sound as following:Two short beeps after every two seconds.In case such an alarm is audible, kindly switch off the purifier and call the service technician for help.The purifier will stop its purification process in such a circumstance.UV Fail Alarm*2 Sec. 2 Sec. 2 Sec.2 Sec.2 Hours30 Sec. 30 Sec.To ensure delivery of purer and healthier water, a micro-processor is installed in the purifier thatperforms the following functions: -UV Stabilisation Delay: To ensure that the UV lamp is pre-heated and is working at its optimum levelbefore it starts disinfecting water, the controller provides a two seconds delay to UV lamp when thepurifier is switched on. During this period, only the UV lamp is switched on and other electrical devicesof the purifier are switched off.Purification Delay: To ensure that the idle water lying in the internal pipes and in the UV chamber isdisinfected before being passed into the storage tank, the system provides 5 second delay when thepurifier is switched on. During this time, the UV lamp kills all micro-organisms that may be in the waterinside UV chamber. After this delay, all other electrical devices such as booster pump and solenoidvalve are switched on to start normal purification process.Audible Alarm: The controller also controls the timing of UV Fail Alarm and the Filter Change Alarm.Computer Controlled Operation** Tested & Certified by TUV-SUD South Asia (P) Ltd.Installation Procedure :1. Screw in two 10x50 self taping screws, 5.4 inches (138 mm) apart horizontally.(in case of wall mounting).2. Wall-mount the purifier with the help of slot holes given on back side.3. Fasten the SS ball valve to ¼ inch port of 3-way connector.4. Attach threaded end of 3-way connector to raw water supply and plug offthe other end or connect to a tap.Slot holesTMKENT Pearl Mineral RO is designed to facilitate both wall mounting as well as thecounter-top usage.The purifier is easy and convenient to install.Recommended Site Preparations:supply not more than 3m away from the pointof installationRaw water supply with ½ inch nipple not more than 3m awayDrain for reject water not more than 3m awayInstallation space as per dimensions of the purifierFor wall mounting installation, make sure that purifier is mounted on a wall. Avoid installation onwooden and metallic standsFor optimum inlet pressure, source water tank should be at least 10 ft above the purifier installedInstall the purifier near a sink for easy availability of inlet and reject water linesThe system and installation must comply with state and local laws and regulationsnnnnnnnnSingle Phase 220 ± 10 V AC, 50 HzInstallation Instructions

/ 9

Related manuals for KENT Pearl Mineral RO