Menu
KENT 9087112020 Instructions For Use Manual
                                                                                            | |
Contents
| 
ENGLISH INSTRUCTIONS FOR USE12 909 6309 000(3)2009-11 Razor SV17MACHINE START AND STOPStarting the machinePrepare the machine as shown in the previous paragraph.1.Lower the squeegee (11) with the lever (19).2.Turn the solution low control lever (4) to a position between the minimum limit (5a) and maximum limit (5b). In no case it is3.possible to close completely the water low to the brushes during operation.While keeping the hand on the handlebar (2), start the machine by turning the brush/pad-holder switch and the vacuum system4.switch (65 and 66) to “I”.NOTEIf the green warning light (62) turns on, the batteries are ready to be used. If the yellow or red warning light (63 or 64)turns on, the batteries must be charged (see the procedure in Maintenance chapter).Stopping the machineTurn the brush/pad-holder switch and the vacuum system switch (65 and 66) to “0”.5.Lift the squeegee with the lever (19).6.Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).7.MACHINE OPERATION (SCRUBBING/DRYING)Start the machine as shown in the previous paragraph.1.While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the loor.2.If necessary, adjust the solution quantity by using the lever (4).3.CAUTION!To avoid damaging the loor surface, do not use the brushes without the solution and, when the machine is notoperating, stop the brush/pad-holder by pressing the switch (65).CAUTION!Before lifting the brush/pad, turn it off by pressing the switch (65).NOTEFor correct scrubbing/drying of loors at the sides of the walls, KENT suggests to go near the walls with the right side ofthe machine as shown in igure 3.ABFigure 3P100160ACAUTION!In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from turning, or toexcessively aggressive loors/brushes, the safety system stops the brush/pad-holder after about one minute ofcontinuous overload.The overload is shown by the three warning lights (62, 63, 64) lashing simultaneously.If the overload persists, the brush/pad-holder stops.To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the brush/pad-holder switch and the vacuum system switch (65 and 66) to “0”. Turn on the machine by turning the brush/pad-holder switch and the vacuum system switch (65 and 66) to “I”.https://harrissupplyind.com - To Order Parts Call 608-268-8080 |
Related manuals for KENT 9087112020
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved