Menu
KENT 9087112020 Instructions For Use Manual
                                                                                            | |
Contents
| 
INSTRUCTIONS FOR USE ENGLISHRazor SV17 909 6309 000(3)2009-11 11Battery installationDisconnect the vacuum hose (22) from the squeegee (11).6.Disconnect the recovery water drain hose (16) from the7.bracket (17).Open the cover (6).8.Grasp the recovery tank (A, Fig. 2) in the area (B) and9.slightly raise it.Disconnect the vacuum hose (C) from the tank, then10.remove the tank (A) with the hoses (D) and (E).Install the batteries on the machine according to the11.diagram (28).Install the tank (A, Fig. 2) by performing steps 6 to 10 in12.the reverse order.Battery chargingCharge the batteries (see the procedure in Maintenance13.chapter).ACBDEFigure 2S310233 ABEFORE MACHINE START-UPBrush or pad-holder installationNOTEUse either the brush (54) or the pad-holder (55) according to the type of loor to be cleaned.Insert the positioning pin (24) and disengage the machine transport/parking device (23b).1.Lift the brush/pad-holder deck (10) by prying the handlebar (2).2.Place the brush (54) or the pad-holder (55) under the deck.3.Lower the deck (10) by using the handlebar (2).4.Engage the brush/pad-holder by pressing the brush/pad switch (65) for a few seconds. If the procedure is dificult, manually5.turn the brush/pad-holder counter-clockwise (60).Brush/pad application guide (suggestions only)Types of brushes available Midlite Grit 180 Midgrit 240 Prolite Union MixGeneral cleaningConcreteTerrazzo loorCeramic tiles/quarrystonesMarbleVinyl tilesRubber tilesPolishingRubber tilesMarbleVinyl tilesSqueegee installationInstall the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.6.Solution tank illingOpen the recovery water tank cover (41) and engage the support rod (59).7.Use the iller neck (45) to ill the tank (32) with a solution suitable for the work to be performed. Do not ill the solution tank8.completely, leave a few centimetres from the edge. Always follow the dilution instructions on the label of the chemical productused to prepare the solution. The solution temperature must not exceed 104°F (40°C).CAUTION!Use only low-foam and non-lammable detergents, intended for automatic scrubber applications.AdjustmentsAdjust the handlebar (2) with the knobs (3) to reach a comfortable position.9.https://harrissupplyind.com - To Order Parts Call 608-268-8080 |
Related manuals for KENT 9087112020
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved