Kärcher BR 400 Manual

Contents

Kärcher BR 400 Manual Manual pdf 6 page image

BR 40013EnglishCaution:The transport position can only be selected when the push handleis in a vertical position.Position the push handle vertically when turning off the unit inorder to avoid damaging the brushes.• The floor cleaning unit is equipped with four, small-diametertransport wheels. Movement is no problem indoors or on evensurfaces.• Use care when on outdoor surfaces such as rough asphalt,cobblestones, etc.• Polishing is carried out without water and without vacuuming. Ifrequired the tanks can be removed, facilitating polishing underfurniture, etc.Caution:To avoid damaging the floor due to overheating, do not allow theunit to run in one place.If necessary, reduce the brush pressure.PolishingApplicationNote: The unit is constructed symmetrically, having vacuum bars atthe front and rear. It therefore works equally well in either direction.• Loose coarse dirt particles must be removed by sweeping beforeusing the floor cleaning unit.• The amount of water should always correspond to the floorcovering and degree of dirt.• Select the correct brushes (see Accessories).• The brushes are offset, enabling the unit to operate up to edgeson the left and right.• The vacuum lips are fitted at the front and back enabling the unitto operate in a forward or reverse direction.Transporting the unitStopping operation • Release switch lever and spray button.• Latch the push handle into the vertical position.• Lift the vacuum bars using the foot key.• Engage in the transport position using the side switch.• Disconnect the mains cable.• Remove, empty and clean both tanks.• On completion of work, pressure must always be removed fromthe brush rollers: either the handle must be in the vertical centreposition, or the running gear (transport rollers) must be locked inthe extended position when the handle is folded down.• If the unit is not used for a prolonged period, rinse thoroughly withfresh water to prevent the pump from malfunctioning.