SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER56 JVC PROFESSIONAL, IMAGING PRODUCTSNOTE: The system will always complete normal alarm action before executing the macrofunction.FULLSCREEN ALARMThis option allows setting the system to display only a FULLSCREEN image on Monitor-A instead ofthe default multiscreen (or associated alarm camera displays) for any alarm input. See section 4.9.NOTE: This is a global setting and will apply to ALL alarms.RELAY CONFIGURATIONEach relay (1 & 2) can be configured for N/OPEN (normally open NO) or N/CLOSED (normallyclosed NC). This menu item allows selection of either NC or NO configuration.BUZZER SETUPThe internal buzzer is programmable to respond under various conditions. The sub-menu item underALARMS is as follows:"" Global Buzzer – Set to OFF if some Buzzer responses are not to be active."" Live Alarm Buzzer – Set to OFF if no Buzzer is desired on incoming Live Alarms."" Video loss Buzzer – Set to OFF if no Buzzer is desired on video loss detection"" Playback Buzzer – Set to OFF if no Buzzer is desired on during the playback ofVideotapes where alarms are present.VIDEO LOSS ACTIONThis option is used to specify what is to happen in the event of loss of a video input. Video loss canoccur due to a failed camera or disconnection of the video signal to the multiplexer.Video Loss action in LIVE Mode:Monitor-A: If the camera is being displayed at the time that video loss occurs, the camera imagewill be frozen. However, if sequencing is in progress, the display will be blankedwhen it is switched to a camera experiencing video loss.Monitor-B: Monitor-B cannot freeze images, and so the display will always be blanked while acamera with video loss is selected.Video Loss action in RECORD Mode:When video loss is detected, the affected camera is temporarily removed from the record list, and thecoded digital data recorded with each field will be updated to indicate a video loss situation on theaffected camera. This video loss status is then shown during Playback. The SW-D7000U continuesBuzzer SetupGlobal Buzzer :ONLive Alarm Buzzer :ONVideoloss Buzzer :ONPlayback Buzzer :ON[CANCEL] [OK]