Filename [VS30U_3-EN.fm]Masterpage:Left54 ENPage 54 January 31, 2002 3:40 pmEDITING (cont.)Normal Dubbing(from DV to VHS)NOTES:● If you set the dubbing direction incorrectly, you could erase animportant recording that you wanted to copy. It isrecommended to conduct a test with unimportant cassettesfirst.● There may be a discrepancy of several seconds between whereyou intend editing to start, and where it actually starts.● The superimposed indication during the operation or dubbingis not recorded.● To cancel the dubbing mode, press CH +/– so that the dubbingdirection indicator (DV ) goes off.● When dubbing a Mini DV tape that was produced by audiodubbing, you need to set “12BIT MODE” to the appropriatemode before playing back the tape. ( pg. 76)You can dub selected scenes on a tape, starting andstopping wherever you wish.A Load cassettes.For the VHS deckInsert a VHS (or S-VHS) cassette with the record safetytab intact, or cover the hole using adhesive tape.For the DV deckInsert a Mini DV cassette with the erase protection switchset to “SAVE”.B Select the dubbing direction.Press .● The dubbing direction indicator (DV ) lights.C Set the tape speed.Press S-VHS, then press SP/EP (p).● “DV ] VHS” appears on the TV screen if “SUPERIMPOSE” isset to “ON”. ( pg. 71)D Locate the start point on the DV deck.A Press DV.B Press PLAY (4) to start playback.C Press PAUSE (9) to pause playback a little before thestart point.E Prepare the VHS deck for dubbing.A Press S-VHS.B Press and hold PAUSE (9) and press REC (7) so thatthe VHS deck enters the Record Pause mode.● DV playback indicator and VHS recording indicator light.F Start dubbing.Press START.G Pause dubbing.Press START.● The VHS deck enters the Recording Pause mode, then the DVdeck enters the Dubbing Pause mode.H End dubbing.Press STOP (8) to stop recording on the VHS deck. Thenpress DV and press STOP (8) to stop playback on the DVdeck.1 3 21 2 34 5 67 8 902413T WDV S-VHSVS30U_3-EN.fm Page 54 Thursday, January 31, 2002 3:40 PM