JVC RM-LP25U Instructions Manual

Also see for RM-LP25U: Instructions Instructions

12Getting StartedControl Panel (continued)P [CALL] Send Call Button and Indicator LightPress this button to call the camera operator. (Calling can beperformed without making use of sounds, such as throughintercoms.)It also shows the calling status at the camera's end.Memo:� When call signals are generated from both the [CALL]button and the camera at the same time, priority is givento the call signal from the camera (blinking orange).Note:� The feature is not available on the camera if the light ofthe corresponding button is not lit. Control using this unitis disabled in this case.Q [PREVIEW] Preview Button and Indicator LightPressing this button sends make output to the previewterminal.U.R [KNEE POINT/AUTO KNEE] Knee Control Unit[AUTO KNEE] Auto Knee button and indicator light:For specifying whether the knee operation, whichcompresses video signals beyond a specific level in order torepresent the gray level of a highlighted area, is to beperformed automatically or manually.To check the brighter areas, set to �OFFB and adjust theknee point manually.Names and Functions of Parts(continued)-3LEVEL LEVELGAMMA DETAIL KNEE POINT AUTOKNEEBLACKCOMPRESS STRETCHRRPAINTPAINTAUTO WHITEAUTO BLACKAUTOOVER OPENUN CLOSESTERACKTALLYCALL PREVIEW1OPERATE BARSLOCKPARTOFF FULLSCENE FILE2 3 54SPEEDPART RNOR 1/1000 1/200W A AW BPARTSETFULLBEGCHORS�PQFR PA NT AUTO BLACK-30SPEEDRNOR 1/1000 1/20PARTR PA NT AUTO WH TEW A AW BAUTOOVER OPENUN CLOOSSSESTERACKPARTSETEPARTNDIJLMKON(Orange lighton): When you press and hold this button,the indicator lights up in orange, and thetally lamp at the camera's end appearsblinking.OFF(Green lighton): When you release the button, theindicator light turns off, and the tallylamp at the camera's end stops blinking.Blinkingorange light: Upon receiving a call (CALL ON signal)from the camera, the indicator starts toblink in orange. Upon receiving acommand to cancel a call (CALL OFFsignal) from the camera, the indicatorlight switches to solid green.ON(Orange light on): When you press and hold thisbutton, the indicator lights up inorange, and output is sent to themake contact.OFF(Light off): When you release the button, theindicator light turns off and outputto the make contact is canceled.ON(Orange light on)Turns �ONB auto knee control,and the knee point is setautomatically.OFF(Green light on)Turns �OFFB auto knee control.Turn the [KNEE POINT] knob andadjust the knee point manually.