JVC NX-F7 Instructions Manual

Also see for CA-NXF3: Instructions Instructions Service manual

Contents

Playing back sources from external devices18■ IMPORTANT• Slide the remote control modeselector to [AUDIO].1 Press [AUDIO IN] or [DIGITAL IN].• Pressing [AUDIO IN] displays “AUDIO IN”and selects the device connected to the[AUDIO IN] terminals.• Pressing [DIGITAL IN] displays “DGTL IN”and selects the device connected to the[DIGITAL IN] terminal.• You can also select the connected device asthe source by repeatedly pressing[SOURCE] on the main unit.2 Start playback on the connecteddevice.3 Adjust the volume or the soundquality for your preference.• Refer to page 12.NOTE• Refer also to the operation manual for the con-nected device.• You can also operate your digital broadcast satel-lite and video cassette recorder using the remotecontrol of this system. Refer to pages 48-50.You can select the gain of the signal from the[AUDIO IN] terminals. Use the initial settings fornormal operation. If the sound is too small or tooloud, change the settings.1 Press [AUDIO IN].• “AUDIO IN” appears in the display window.2 Hold down [ENTER].• “LEVEL 1” or “LEVEL 2” appears in the dis-play window.3 Press [ENTER] repeatedly toselect “LEVEL 1” or “LEVEL 2”.• Each time you press [ENTER], the displaytoggles between “LEVEL 1” and “LEVEL 2”.• The signal gain in “LEVEL 1” is lower thanthat in “LEVEL 2”.• The display returns to “AUDIO IN” in approx-imately 5 seconds.Remote controlmode selectorPlaying back sources fromexternal devicesSelecting the signal gainPlaying back sources from external devicesNX-F3_NX-F7[A]EN.book Page 18 Tuesday, April 22, 2008 1:55 PM