JVC MC-8100U Service Manual

Contents

MC-8100U12.1.4 Removing the Drive1. Open the door. (Refer to 2.1.2.)2. Remove the side cover (R). (Refer to 2.1.8.)3. Remove the rear panel. (Refer to 2.1.9.)4. Disconnect the two connector cables from the drive.5. Disconnect all the SCSI cables from all the drives and theSCSI PCB. (When removing the drive in the uppermost slotamong the currently mounted drives, disconnect the cableconnected to the uppermost drive only.)6. Remove the screw 1 located on the side of the drive (doorpanel side).2.1.5 Removing the side stay R1. Open the door. (Refer to 2.1.2.)2. Remove the C panel. (Refer to 2.1.2.)3. Remove the side cover R. (Refer to 2.1.8.)4. Remove the four screws 2 to remove the side stay R.Note:Side stay R must be removed when removing the carriermechanism.Photo shows situation when removing the Drive 2Photo shows situation when removing the Drive 2SCSI cableConnector cable27. Remove the drive from the rear.2-4