Menu
JVC LX-WX50 User Manual
                                                   |
33Controlling the projector remotelyiii. You can adjust the LAN Settings.iv. Once set, access to the remote network operation page on this projector has beenpassword-protected. To enable this function, check the box in front of "Enable" and typein your desired password in the New Password column and confirm the new passwordby re-entering the new password at the Confirm column. To disable password protection,uncheck the box.v. Once set, access to the Tools page has been password-protected. Refer to step iv forhow to use the password function.vi. Press Exit to go back to the remote network operation page.After making the adjustments, press the Send button and the data will be saved in theprojector.Once the password is set, the Log Out button will display beside the Tools button.Write down your selected password in advance or right after the password is entered so thatit is available to you should you ever forget it.If you did not write down your password, and you absolutely do not remember it you can resetthe password by following procedure.• Open log in screen of e-Control™ by your web browser.• Long press on MENU and on the projector for 3 seconds.• Now the password has been reset.The software is available in English language.When DHCP is turned on, there is a possibility of stopping the webpage connection. If thishappens, please check the new IP address of the projector and enter the new address toconnect again.4. The Info page displays the information and status of this projector.i. The information you entered in the Tools page will display here and these columns areempty when you use e-Control™ for the first time.ii. When the projector is in abnormal conditions, the following information will display.Error Status Description0: No Error The projector is in normal conditions or in any abnormalconditions other than the ones mentioned below.3: Lamp fail The lamp fails to ignite or turns off during operation.3: Over Temp The projector temperature is too high or cannot be detected.3: Fan Lock The fan rotation speed cannot be set or detected.3: Over Lamp Usage Time The lamp is still in use after the lamp warning messages display.iiiiiii |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved