JVC KM-H3000 User Manual

Also see for KM-H2500: Instructions Manual 

4To install switcher button inserts:1. Remove the Cap Assembly (1) from the SwitchAssembly (2) by grasping it firmly and pullingaway from the control panel surface.2. Remove the Lens (1) from the Diffuser (2) usinga common end micro screwdriver.3. Place the Insert Film (2) into the Lens (1) so thereadable side is facing up. The notches on thesides of the Lens must be at the sides of the texton the Insert Film.4. Aligning the notches on the sides of the Lens (1)and Diffuser (3), press the Lens and Diffusertogether until they click.5. Aligning the notches on the sides of the CapAssembly (1) to the tabs on the side of theSwitch Assembly (2), press Cap Assembly downonto the Switch Assembly with a rolling motionuntil they click together.ShiftShifting allows access to the secondary sources foreach source button.To shift a bus and access the secondary sources:1. Press and hold SHIFT.2. Press the required source button to access thesecondary source.FaderThe Fader is used to manually perform a wipe ordissolve transition. Move the Fader handle from onelimit to the other to perform a transition.TransitionsThe progress of the transition is shown on theProgress Bar to the left of the Fader handle. As theFader handle moves from one limit to the other, theProgress Bar indicates the progress of the transition.PositionerThe KM-H3000 has a joystick positioner forpositioning wipes, patterns, washes, and DVE effects.The KM-H2500 does not have a positioner.Selecting ColorsFunctions such as mattes, and Panel Glow haveoptions for adjusting the appearance of a selectedcolor. Individual adjustments for colors are:• Luminance• Hue• SaturationLuminanceLuminance affects the brightness of the video signal.Increasing luminance gives a brighter color whiledecreasing luminance gives a darker color.HueHue controls the shade of color (red, yellow, green,blue, etc.).2121CUT2312112