21• Magenta6. Press Init.For More Information on...• selecting Keys, refer to the section “SelectingKeys” on page 19.• Chroma Key sharing, refer to the section“Resource Sharing” on page 14.• modifying Chroma Key settings, refer to thesection “Chroma Key Fine Tuning” on page 31.• taking a Chroma Key on-air, refer to the section“Key Transitions” on page 19.MattesA Matte is a solid color signal that is generated by theswitcher and can be adjusted for hue, saturation, andluminance. It can also be adjusted for position, size,aspect, border, and softness.For More Information on...• setting hue, saturation, and luminance, refer to thesection “Selecting Colors” on page 4.Using a MatteMattes can be a solid color or a wash. A wash fills thematte with one of the 10 patterns.Selecting a Matte ColorYou can use two methods to select a matte color:• Specify hue, saturation, and luminosity• Load a preset colorTo select a matte color by specifying hue,saturation, and luminosity:1. Press and hold SHIFT.2. Press BLACK/MATTE to display the Mattemenu.3. Use the corresponding knob to adjust the Hue(Hue1), Saturation (Sat1), and Luminance(Lum1) to the desired effect.To select a matte color by loading a preset:1. Press and hold SHIFT.2. Press BLACK/MATTE to display the Mattemenu.3. Press NEXT.4. Rotate the Load knob to select the preset coloryou wish to use.5. Press the Load knob to load the preset color.To change the pattern:1. Press and hold SHIFT.2. Press BLACK/MATTE to display the Mattemenu.3. Press NEXT until WASH is displayed.4. If the WASH knob is Off, toggle it On by pressingthe WASH knob.5. Use the Pattern buttons to select the desiredpattern.Note:• If the wash is turned off, the pattern does notdisplay.Using other AdjustmentsMattes can also be adjusted by using these modifiers:• Size — Size• X-Pos, Y-Pos — Position• Aspect — Aspect Ratio• Border — Border Appearance• Softness — Edge Softness• Hue 2, Sat 2, and Lum 2 — Secondary Color31243125 4312