JVC KD-G401 Instructions Manual

Also see for KD-G401: Instructions Installation & connection manual Service manual Service manual Manual

29ENGLISHAdjusting the soundYou can adjust the sound characteristics to yourpreference.1 Select the item you want to adjust.Each time you press thebutton, the adjustable itemschange as follows:Indication To do: RangeBAS *1 Adjust the bass. –06 (min.)|+06 (max.)TRE *1 Adjust the treble. –06 (min.)|+06 (max.)FAD*2 Adjust the front R06 (Rear only)and rear speaker |balance. F06 (Front only)BAL Adjust the left L06 (Left only)and right speaker |balance. R06 (Right only)LOUD* 1 Boost low and highfrequencies to LOUD ONproduce a well- |balanced sound LOUD OFFat low volumelevel.VOL *3 Adjust the volume. 00 (min.)|30 or 50 (max.) *4*1 When you adjust the bass, treble, or loudness, theadjustment you have made is stored for thecurrently selected sound mode (C-EQ) including“USER.”*2 If you are using a two-speaker system, set the faderlevel to “00.”*3 Normally the control dial works as the volumecontrol. So you do not have to select “VOL” toadjust the volume level.*4 Depending on the amplifier gain control setting.(See page 32 for details.)2 Adjust the setting.3 Repeat steps1 and2 to adjust theother items.To reset each sound mode to the factorysettings, repeat the same procedure andreassign the preset values listed in the table onpage 28.To decrease the level orturn off the loudnessTo increase the level orturn on the loudnessIndication pattern changes asyou adjust the bass or treble.Ex. 1: When you adjust “TRE” (treble)Ex. 2: When you turn on the loudnessVOL(volume)BAS(bass) TRE(treble) FAD(fader)BAL(balance)LOUD(loudness)