The setting adjusted applies to all inputs.+ You can change the aspect ratio by pressing ASPEC L (Seepage 15.)1 Press MENU/EXIT (or MENU on theMonitor) to display the Main Menu.Cursor(_)-- MENU>FUNCTION SELECTSTATUS DISPLAYENTER:_ SELECT:_ EXIT:_23Press A/v to move the cursor (_) to"FUNCTION SELECT."Press _ to display the FunctionSelection Menu. SELEOT>I_COLOR TEMP : NIGHASPECT : PANORAMICSIGNAL MODE : AUTORGB/COMPO : RGB--SYNC TERM : HIGH_resetADJ UST:_I_ SE LECT:[_ EXiT:_"1 "S]IGNAL MODE" appears only when VIDEO A,VIDEO B, or COMPONENT input is selected.*2 "RGB/COMPO." appears only when the RGBB or COMPONENT input is selected.*3 "SYNC TERM." appears only when the RGB Binput is selected.4 Press A/T to move the cursor (_) to"ASPECT."56Press 4/_ to select an aspect ratio youwant.Each time you press the button, the, aspect ratio changesas follows:_p REGULAR "_ FULL_ANORAMIC_ ZOOM_* For detailed information on these aspect ratios, seepage 15.Press MENU/EXIT (or MENU on theMonitor) twice to exit from the menuoperations.Note:+ When one of the following signals is being input, youcannot select the aspect ratio you want.[] 1080/50i, 1080/60i, 1035/60i or 720/6017 signal through theCOMPONENT/RGB B input terminalsAspect ratio is fixed to FULL ("ASPECT" will not appearon the display).[] When m_y signal other thm_ RGB15K-60 m_d RGB15K-50through the RGB A or COMPONENT/RGB B input termin_lsYou can select only REGULAR and FULL.You can set the receivable signal types. Normally, select"A U['0."A common setting will apply to both the VIDEO A input andthe VIDEO B input, and a different setting will apply to theCOMPON EN[" input.1 Press MENU/EXIT (or MENU on theMonitor) to display the Main Menu.Cursor(_)-- MENU>FUNCTION SELECTSTATUS DISPLAYENTER:_ SELECT:_ EXJT:IMENZ_23456Press A/T to move the cursor (_) to"FUNCTION SELECT."Press _- to display the FunctionSelection Menu. SELECT>_-COLOR TEMP : NIGHASPECT : PANORAMICSIGNAL MODE : AUTORGB/COMPO : RGB--SYNC TERM : NIGH_resetAD J U ST:[_]_ S E L E CT:r4] EXIT:_• 1 "SIGNAL MODE" appears only when VIDEO A,VIDEO B, or COMPONENT input is selected.•2 "RGB/COMPO." appears only when the RGBB or COMPONENT input is selected.•3 "SYNC TERM." appears only when the RGB Binput is selected.Press A/T to move the cursor (_) to"SIGNAL MODE."Press _/_ to select the receivable videosignal type.Each time you press the, button, the receivable videosignal type changes as follows:+ When VIDEO A or VIDEO B input is selected:_ AUTO _ ,_ NTSCPAL N _ PAL M_+ When COMPONENT input is selected:A UTO -.,,,_ 480i -,,,_,_ 576i _.-- I1080i _,_,,.- 720 p_,_,,,- 480 p _(1035i)** Changes according to the "HD SIGNAL MODE"setting (see page 27).Press MENU/EXIT (or MENU on theMonitor) twice to exit the menuoperations.21
