JVC 2A73501A User Manual

Also see for HR-XV1EU-C: Service manual Service manual Service manual

Contents

9Remote control1 2 3 Replace the compartmentcover.Install two "AA" batteries (notsupplied), paying attention to thepolarity diagram in the batterycompartment.Open the battery compart-ment cover in the direction ofthe arrow.How to install the batteriesUse micro batteries type R6.Distance of RemoteControl OperationBattery precautionsThe precautions below should be followed when using batteries in this device:1. Use only the size and type of batteries specified.2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury frompossible battery leakage.5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.Change the custom code for remote controlIf you operate this DVD/VCR with another JVC’s VCR simultaneously arranging them side by side, the bothrecorders will react to this remote control. In this case, you can change the remote control and DVD/VCR toother frequency (“ ”). Then you can operate only this DVD/VCR with this changed remote control.When you purchased, the DVD/VCR and remote control have been set to the frequency-“ ”.Example: Change frequency toRemote control:While holding VCR, press 2 (code: b) of Number keys.(in case of code: A, press 1). Then press OK.DVD/VCR:In the POWER off mode, press and hold PLAY formore than 5 seconds. The current code (“A” or “b”) willappear on the display. Then press 3 on the remotecontrol. The current code of the remote control will betransmitted to the unit and the unit will be adjusted tothe transmitted code. Then the code will disappearafter approx. 4 seconds.NOTE:• If the remote control has been set to b, the DVD/VCR also must be set to b. Otherwise, the DVD/VCR can notbe operated with this remote control.• To reset to “A”, repeat above procedure. However press 1 instead of 2.Effective angle:approx. 60°approx.5mPoint the remotecontrol directly at theremote sensor.