JVC 1010MTH-SW-MT Instructions Manual

Contents

Changing PlaybackSettingsDisplaying the playback settings menu1 Press the [PB MODE] button on the remotecontrol unit during the playback of a titlev The Settings Menu screen appears.v The playback settings menu can only be displayed duringthe playback of a title.v Only settings that are supported by the current title beingplayed back can be changed in the playback settingsmenu.Items displayed in gray cannot be set.Playback Settings MenuAudio/subtitle settings.#7&+157$6+6.'#7&+1.#0)7#)'%*#0)'#7&+1176276 .457$6+6.'.#0)7#)'Memo:v “AUDIO/SUBTITLE” will be displayed only if they areavailable in the video content. The setting value differsdepending on the content. Items that are not available inthe content cannot be set.m AUDIO LANGUAGEm CHANGE AUDIO OUTPUTm SIGNAL TYPE (BD-ROM)v PRIMARY VIDEOv PRIMARY AUDIOv SECONDARY VIDEOv CHANGE SECONDARY VIDEOv SECONDARY AUDIOv SECONDARY AUDIO LANGUAGEm SUBTITLE LANGUAGEm SUBTITLE STYLEm CHANGE ANGLEPlayback settings.2.#;$#%-5'66+0)4'2'#6 1((%*#0)'6+6.'%*#0)'%*#26'46+/',7/2m REPEATThe following items can be set.Items are not displayed if they cannot be set.Setting Values DescriptionOFF Turns off repeat.TITLE Repeats playback of the currently playedtitle.CHAPTER Repeats playback of the currently playedchapter.TRACK Repeats playback of the currently playedtrack.FOLDER Repeats playback within the currentlyplayed folder.ALL Repeats playback of the entire disc.A-B Repeats playback of the section between thespecified starting and ending points.Pressing the [OK] button specifies thedisplayed scene as the starting point (PointA). Pressing the [OK] button after forwardingplayback specifies the displayed scene as theending point (Point B).m CHANGE TITLEYou can change to a different title by entering the correspondingnumeric value. Any value that is larger than the number of titlescannot be entered.m CHANGE CHAPTERYou can change to a different chapter by entering thecorresponding numeric value. Any value that is larger than thenumber of chapters cannot be entered.m TIME JUMPYou can move to a specific playback position by entering a time.This is not possible if the specified time is not valid.m SLIDESHOW INTERVALThe following items can be set.3SEC/5SEC/10SEC/20SEC/30SEC modesm SLIDESHOW EFFECTSThe following items can be set.Setting Values DescriptionOFF Turns off slideshow effect.ON Turns on slideshow effect. “Fade out” and“Fade in” effects can be applied whenswitching from one slide to another.Playing Back56