JVC 0403MNMCREJEM Instructions Manual

24Using the Timers3 Press the SET button.The minute digits of the time indication blink on the dis-play.• To return to the hour setting, press the CANCELbutton.4 Press the 3 or 2 button to set the minute.5 Press the SET button.“ADJUST OK!” appears on the display. The Clock in-dicator ( ) remains lit. Then, the selected time is setand the seconds start counting from 0.CAUTION:• If there is a power failure, the clock loses itssetting. “0:00” and the Clock indicator ( )blinks on the display and the clock must bereset.Showing the Clock (DISPLAY)You can show the current time on the display.To display the clock, press the DISPLAY button on theRemote Control.To return to the normal display, press the same buttonagain.Correcting the ClockUse the following method to correct any clock shift.❑ You can correct the clock whether the System is turnedon or off.1 Repeatedly press the CLOCK/TIMER bu-tton to show the clock on the display.Each time you press the button, the display changes asfollows.Example:2 Perform steps 2 to 5 in “Setting the Clo-ck” on page 23-24.• When the System is in power saving mode, nothing ap-pears on the display. To see the clock, press the DIMMERbutton on the Remote Control.• The clock may gain or lose one to two minutes per month.• If there is a power failure, the clock loses its setting, “0:00”blinks on the display and the clock must be reset. To resetthe clock, see “Setting the Clock” on page 23-24.Setting the Daily TimerOnce you have set the Daily Timer, the timer will be acti-vated at the same time every day.The “DAILY” indicator on the display shows that the DailyTimer you have set is in effect.You can set the Daily Timer whether the System is on or off(but not in power saving mode (See page 10)).• If you have made a mistake while setting the timer, pressthe CANCEL button on the Remote Control. However, thisdoes not always cancel the current setting. If the CANCELbutton does not work, press the CLOCK/TIMER button onthe Remote Control repeatedly until the display returns tothe original display, and start from the first step.Alternates(clock)Display the source(clock is canceled)