JVC 0403MNMCREJEM Instructions Manual

18Using the CD Player❑ You can insert a CD while listening to the other source.• However, while the CD door is operating (opening orclosing), the other source will be muted.CAUTION:• DO NOT try to open or close the CD door byhands as it will be damaged.To Unload a CDTake out the CD as shown below.Basics of Using the CD Player– Normal PlayTo Play a CD1 Select the source “CD”.2 Insert a CD.3 Press the 6 button on the Unit or theCD 6 button on the Remote Control.The first track of the CD begins playing.• The CD Player automatically stops when the lasttrack of the CD has finished playing.To stop playing the CD, press the 7 button.The following information for the CD is displayed.To stop playing and remove the CD, press the 0CDbutton on the Unit or the CD DOOR 0 button on the Re-mote Control to open the CD door.To pause, press the 6 button on the Unit or the CD 6button on the Remote Control. The playback time blinks onthe display.To cancel pause, press the same button again. Play con-tinues from the point where it was paused.To Select a Track or Passage within a TrackDuring playbackPress the ¢ or 4 button on the Unit or the 3 or 2 but-ton on the Remote Control to select the track you want.• The selected track starts playing.• Press the ¢ (or 3) button once to skip to thebeginning of the next track.• Press the 4 (or 2) button to skip to the beginningof the track being played. Press twice quickly to skipto the beginning of the previous track.• When the 3 or 2 button on the Remote Control iskept pressing, the track continuously skips.• Press the Numeric Keys to select truck number (Seepage 11).In Stop mode• Press the ¢ or 4 (or 3 or 2) button to skip thetrack.• Hold down the ¢ or 4 (or 3 or 2 ) button tocontinuously skip the tracks.Search PlayHolding down the ¢ or 4 button on the Unit or the 5or ∞ button on the Remote Control, during playback, willfast forward/backwards the CD so you can quickly find aparticular passage in the track you are listening to.Programming the Playing Orderof the Tracks – Program PlayYou can program up to 32 tracks in any desired order in-cluding the same tracks.❑ You can only make a program when the CD Player isstopped.On the Remote Control1 Insert a CD.2 Press the CD 6 button.3 Press the 7 button to stop the CD.4 Press the FM/PLAY MODE button until“CD PROGRAM” appears.The System enters the Program Play mode and the“PRGM” indicator lights up.Each time you press the button, the play mode changesas follows.CD PROGRAM=CD RANDOM=CD NORMAL=(back to the beginning)• If already programmed, the track number and presetnumber of the last programmed track will appear.Track number Playback timeTotal track number Total playback time(After a few seconds)