JBL Cinema BD100 Owner's Manual

Contents

JBL Cinema BD100 Owner's Manual Manual pdf 28 page image

28TRouBleshooTingIf your BD receiver isn’t performing the way you think it should, check to see if the problem is covered in this section before calling your JBL dealer.PRoBLEM SoLUTIoNThe receiver won’t power up (the On/Standby indicator is not lit): • Check that the receiver’s Power cord is properly plugged into thereceiver’s AC Power connector.• Check that the Power cord is plugged into a working AC outlet. If the outletis controlled by a switch, make sure the switch is set in the “On” position.Sound plays through the speakers, but there is no TV picture: • Check the HDMI connection between the receiver and the TV.• Check the HDMI connection or component video connection between thesource device and the receiver.• Check that the TV is turned on and is set to the proper input source.• Unplug the HDMI cable from the TV and plug it back in again.There is a constant hum in the sound: • Check that all input cables are plugged all the way into their connectors.• Check that all cables are at least 10 ft (3.3m) from fluorescent lights.• Check that all cable connectors are clean. If necessary, wipe them with acloth slightly moistened with alcohol.Streaming service (Pandora, Picasa or YouTube) does not appear on theHome Menu screen:• See the table on page 23 to confirm that the streaming service is availablein your region. If the service is not available, it will not appear on theHome Menu screen.Cannot connect to a streaming service that appears on the Home Menuscreen:• Confirm that the receiver is joined in your home network. See GeneralSettings: Network, on page 17, for information about performing aconnection test.Cannot stream media from other networked devices via DLNA: • Make sure the networked devices have given permission to sharemedia. See Digital Living Network Alliance (DLNA), on page 23, formore information.The disc does not play: • Check that the disc is inserted correctly (label side up).• Check that the disc is the correct type: BD-Video (single-layer or double-layer), DVD-Video, DVD+R/+RW, DVD-R/-RW, CDDA (CD digital audio),CD-R/RW. Other disc types will not play.• Check that the disc surface is clean and not scratched.There is noise or other interference in the picture while playing aBlu-ray Disc recording or DVD:• Check that the disc surface is clean and not scratched.Cannot tune in radio stations: • Check that the FM antenna is correctly connected.• Adjust the antenna’s position. If necessary, use a powered FM antenna oran outdoor FM antenna.The receiver does not respond to remote-control commands: • Replace remote-control batteries with fresh ones, and make sure that theyare installed with the correct polarity.• Hold the remote closer to the receiver.• Check that the receiver’s remote sensor is in the line of sight of theremote control.The Ø symbol appears on the screen when you press aremote-control button:• The selected function is not permitted at the time the button is pressed.The receiver does not respond to commands, or it behaves in anerratic way:• Unplug the receiver’s Power cord from the AC outlet, wait 30 seconds,then plug it back in.You can find additional troubleshooting information in the FAQs link on the Support page at www.jbl.com.

/ 31

Related manuals for JBL Cinema BD100