JAI SP-5000M-CXP4 User Manual

Contents

JAI SP-5000M-CXP4 User Manual Manual pdf 62 page image

SP-5000M-CXP4 / SP-5000C-CXP4- 60 -ALC Channel AreaLow Left R/W OffOn JAI-CustomALC Channel AreaMiddle Low Right R/W OffOn JAI-CustomALC Channel AreaMiddle Low Middle Right R/W OffOn JAI-CustomALC Channel AreaMiddle Low Middle Left R/W OffOn JAI-CustomALC Channel AreaMiddle Low Left R/W OffOn JAI-CustomALC Channel AreaMiddle High Right R/W OffOn JAI-CustomALC Channel AreaMiddle High Middle Right R/W OffOn JAI-CustomALC Channel AreaMiddle High Middle Left R/W OffOn JAI-CustomALC Channel AreaMiddle High Left R/W OffOn JAI-CustomALC Channel AreaHigh Right R/W OffOn JAI-CustomALC Channel AreaHigh Middle Right R/W OffOn JAI-CustomALC Channel AreaHigh Middle Left R/W OffOn JAI-CustomALC Channel AreaHigh Left R/W OffOn JAI-Custom8.10 HDR (High Dynamic Range) (SP-5000M-CXP4 only)HDR sensing mode can be set when HDR Mode is set to ON while Exposure Mode is Timed.The parameters to configure dynamic range are HDR_SLOPE Level 1, Level 2, Level 3 andLevel 4.The user can select any one of those parameters as required for their application.In this mode, the timed exposure is used as the reference and the value selected inHDR_SLOPE will compensate to get an appropriate dynamic range by changing the exposuretime.Notes:1. If the exposure mode is OFF and the HDR mode is set to ON, the exposure mode isautomatically changed to Timed.2. If horizontal binning and/or vertical binning are set to ON, the HDR mode cannot be set.In this case, the HDR mode must be set first before H-Binning and/or V-Binning are set.3. In this mode, exposure overlapped behavior is not available and the frame rate is slower thanthe normal operation.4. The frame rate should be set more than “The width of FVAL + the exposure time”.The width of FVAL = (line number x 165) / Sensor clock (86.4 x 106 Hz).The possible frame rate is more than “The width of FVAL + the exposure time + 100 μs)