Husqvarna SMR Owner's Manual

Also see for 450 Rancher: Operator's manual Operator's manual Operator's manual Spare parts Operator's manual

Contents

33NOTEIn case of throttle control cables (1) and (2) replacement it isnecessary to respect, during reassembly, the measure Á(10mm/0.4 in.), as shown in the picture. Then reassembleguard cover (B) using screw (3) and adjust throttle controlcables on handlebar as described at side.To replace throttle control cables, first remove tha fuel tank asshown on pages 35, 36.Periodically check the connecting hoses (see “Periodical main-tenance card”): this will avoid coolant leakages and conse-quent engine seizure: If hoses (A) show cracks, swelling orhardenings due to sheats desiccation, their replacement shallbe advisable.Check the correct tightening of the clamps (B).BATHROTTLE CABLE ADJUSTMENTTo check the correct adjustment of the throttle operate as fol-lows:- remove the upper rubber cap (1);- by moving cable (2) back and forth check for 2 mm. clearance;- should the clearance be incorrect, unblock the counter ring-nut (3) and turn the adjusting screw (4) (by unscrewing it,the clearance is reduced, while by screwing screw (4) it isincreased);- tighten the counter ring-nut again (3).WARNING*: Operation with damaged throt-tle cable could result in an unsafe ridingcondition.WARNING*: Exhaust gas contains poisonouscarbon monoxide gas. Never run the enginein a closed area or in a confined area.ENABCap6_GB 9-07-2007 16:09 Pagina 33