Husqvarna HG 125 VS Original Instructions Manual

-3-Dress properly. Do not wear loose clothingor jewelry. Keep your hair, clothing andgloves away from moving parts. Looseclothes, jewelry or long hair can be caught inmoving parts.If devices are provided for the connectionof dust extraction and collection facilities,ensure these are connected and properlyused. Use of dust collection can reduce dust-related hazards.Power tool use and careDo not force the power tool. Use the correctpower tool for your application. The correctpower tool will do the job better and safer atthe rate for which it was designed.Do not use the power tool if the switch doesnot turn it on and off. Any power tool thatcannot be controlled with the switch isdangerous and must be repaired.Disconnect the plug from the power sourceand/or the battery pack from the power toolbefore making any adjustments, changingaccessories, or storing power tools. Suchpreventive safety measures reduce the risk ofstarting the power tool accidentally.Store idle power tools out of the reach ofchildren and do not allow persons unfamiliarwith the power tool or these instructions tooperate the power tool. Power tools aredangerous in the hands of untrained users.Maintain power tools. Check for misalignmentor binding of moving parts, breakage ofparts and any other condition that mayaffect the power tool’s operation. If damaged,have the power tool repaired before use.Many accidents are caused by poorlymaintained power tools.Keep cutting tools sharp and clean. Properlymaintained cutting tools with sharp cuttingedges are less likely to bind and are easier tocontrol.Use the power tool, accessories and toolbits etc. in accordance with these instructions,taking into account the working conditionsand the work to be performed. Use of thepower tool for operations different fromthose intended could result in a hazardoussituation.ServiceHave your power tool serviced by a qualifiedrepair person using only identicalreplacement parts. This will ensure that thesafety of the power tool is maintained.Safety Warnings Common forGrinding, Sanding, Wire Brushing,and Abrasive Cutting-OffOperations:This power tool is intended to function as agrinder, sander, wire brush or cut-off tool.Read all safety warnings, instructions,illustrations and specifications providedwith this power tool. Failure to follow allinstructions listed below may result in electricshock, fire and/or serious injury.Operations such as polishing is notrecommended to be performed with thispower tool. Operations for which the powertool was not designed may create a hazardand cause personal injury.Do not use accessories which are notspecifically designed and recommended bythe tool manufacturer. Just because theaccessory can be attached to your powertool, it does not assure safe operation.The rated speed of the accessory must be atleast equal to the maximum speed markedon the power tool. Accessories running fasterthan their RATED SPEED can break and flyapart.The outside diameter and the thickness ofyour accessory must be within the capacityrating of your power tool. Incorrectly sizedaccessories cannot be adequately guarded orcontrolled.Threaded mounting of accessories mustmatch the GRINDER spindle thread. Foraccessories mounted by FLANGES, thearbour hole of the accessory must fit thelocating diameter of the FLANGE.Accessories that do not match the mountinghardware of the power tool will run out ofbalance, vibrate excessively and may causeloss of control.Do not use a damaged accessory. Beforeeach use inspect the accessory such asabrasive wheels for chips and cracks,backing pad for cracks, tear or excess wear,wire brush for loose or cracked wires. Ifpower tool or accessory is dropped, inspectfor damage or install an undamagedaccessory. After inspecting and installing anaccessory, position yourself and bystandersaway from the plane of the rotatingaccessory and run the power tool atmaximum no-load speed for one minute.Damaged accessories will normally breakapart during this test time.