Husqvarna AUTOMOWER 320 NERA Operator's Manual

Also see for AUTOMOWER 430X: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

a) Put the 2 ends of the boundary wire and theend of the guide wire into the coupler.Note: Make sure that you can see the endsof the wires through the transparent area ofthe coupler.b) Push down the cover on the coupler withadjustable pliers to attach the wires in thecoupler.9. Attach the guide wire to the ground with stakes orbury the guide wire in the ground. Refer toTo putthe wire into position with stakes on page 19 orTo bury the boundary wire or the guide wire onpage 19.10. Connect the charging station to the power outlet.3.5.8 To put the wire into position withstakesCAUTION: Make sure that the stakeshold the boundary wire and the guide wireagainst the ground.CAUTION: Cutting the grass too lowright after installation can damage the wireinsulation. Damage to the insulation maynot cause disruptions until several weeks ormonths later.1. Put the boundary wire and the guide wire on theground.2. Put the stakes at a maximum of 75 cm / 30 in.distance from each other.3. Attach the stakes to the ground with a hammer or aplastic mallet.Note: The wire is overgrown with grass and not visibleafter a few weeks.3.5.9 To bury the boundary wire or theguide wire• Cut a groove in the ground with an edge cutter or astraight shovel.• Put the boundary wire or the guide wire 1-20 cm /0.4-8 in. into the ground.3.5.10 To do a visual check of the chargingstation1. Make sure that the indicator LED lamp on thecharging station has a green light.2. If the indicator LED lamp does not have a greenlight, do a check of the installation. Refer toLEDindicator of the charging station for boundary wireinstallation on page 37 andTo install the chargingstation on page 17.2071 - 001 - 29.03.2023 Installation - 19