Honeywell VISTA 15P - Ademco 6 Zone Control Panel Installation And Operation Manual

Also see for ADEMCO VISTA SERIES: Programming guide Programming guide Installation and setup guide Quick guide Faq

Contents

Honeywell VISTA 15P - Ademco 6 Zone Control Panel Installation And Operation Manual Manual pdf 7 page image

S E C T I O N 2Mounting and Wiring the ControlInstalling the Control Cabinet and PC BoardCabinet and Lock 1. Mount the control cabinet to asturdy wall in a clean, dry area,which is not readily accessible tothe general public, using fastenersor anchors (not supplied) with thefour cabinet mounting holes.2. Remove cabinet door, then removethe lock knockout from the door.Insert the key into the lock. CABINET DOORBOTTOMLOCKEDUNLOCKEDcab_lock_snap-001-V0ADEMCOADEMCOPUSHSNAPTABSNAPTABPUSHON LOCKUNTIL ITIS SEATEDSECURELYSTEP 2STEP 1CHECKPOSITIONFigure 1. Installing the Cabinet Lock3. Position the lock in the hole, making certain that the latch will make contact with thelatch bracket when the door is closed. When correctly positioned, push the lock untilthe snap tabs hold it securely.The cabinet can be secured without a lock by using 2 screws in the cover's edge.Mounting the PC BoardAlone (no RF Receiver)Before installing the cabinet's contents, remove the metal cabinet knockouts required forwiring entry. Do not remove the knockouts after the circuit board has been installed.1. Hang two short mounting clips (provided) on the raised cabinet tabs (see Detail B).2. a. Insert the top of the circuit board into the slots at the top of the cabinet. Make surethat the board rests on the correct row (see Detail A).b. Swing the base of the board into the mounting clips and secure the board to thecabinet with the accompanying screws (see Detail B).++CIRCUITBOARDDETAIL BSIDE VIEWOF MOUNTINGCLIPSDETAIL ASIDE VIEWOF BOARDSUPPORTINGSLOTSCIRCUITBOARDMOUNTING-001-V0CABINETCABINETFigure 2. Mounting the PC BoardMounting Board with RFReceiver • Do not mount the cabinet on or near metal objects. This will decrease RF range and/orblock RF transmissions from wireless transmitters.• Do not locate the cabinet in an area of high RF interference (revealed by frequent orprolonged lighting of the LED in the receiver (random flicker is OK)1. a. Remove the receiver board from its case, then insert the top of the board into theslots at the top of the cabinet, as shown in Detail A in Figure 3 on the next page.Make sure that the board rests on the correct row of tabs.b. Swing the base of the board into the mounting clips and secure it to the cabinetwith the accompanying screws.c. Insert the top of the control's board into the slot in the clips and position two clipsat the lower edge of the board.d. Swing this board into place and secure it with two additional screws.2. Insert grounding lugs (supplied with the receiver) through the top of the cabinet intothe left-hand terminals of the antenna blocks (at the upper edge of the receiver board)and secure them to the cabinet top with the screws provided (see Detail B).3. Insert the receiver's antennas through the top of the cabinet, into the blocks' right-hand terminals, and tighten the screws.2-1