Honeywell VISTA-128BPT Programming Manual

Also see for VISTA-128BPT: User guide Overview User guide Installation and setup guide Installation and setup guide

Contents

Honeywell VISTA-128BPT Programming Manual Manual pdf 51 page image

47SECTION 3: DATA FIELD DESCRIPTIONSEExxppeerrtt MMooddee ZZoonnee PPrrooggrraammmmiinnggExpert mode allows you to program zones using the minimum number of screens and keystrokes.Expert Mode Zone Programming does not provide the capability to program some of the zone’sattributes, such as Arm w/Fault, Vent Zone, STAY mode, Auto-STAY, Bypass Group, etc. If you want toprogram a zone for any of these attributes, you must use Zone Programming.Enter the Programming mode with [Installer Code] + 8 0 0 0Before programming your zones, do the following:1. Program field 2∗00: Number of Partitions.2. Enable your RF Receiver in Device Programming menu mode.To program your zones, press #93 to display the "ZONE PROG?" prompt. Enter “0” (NO) to each prompt until the “EXPERTMODE?” prompt appears.PROMPT EXPLANATIONEXPERT MODE?1 = YES 0 = NO 0Press 1 to enter Expert mode.SET TO CONFIRM?0 = NO 1 = YES 0This prompt appears once upon entering Expert Mode.If you select “Yes,” Confirmation prompts will be displayed after the device’s Serial and Loop numbershave been entered later.Zn ZT P RC In L001 03 1 10 HW -A summary display appears, showing zone 001’s current programming or default values. The curserflashes under Zn.Zn ZT P RC In L010 03 1 10 RF 1sEnter the desired 3-digit zone number and press [∗].NOTE: If you want to exit the Expert mode, enter “000” + [∗].If an “s” appears after the loop number, it indicates that the transmitter’s serial number has beenenrolled.Use the [D] key to enter and duplicate wireless keys (see “Entering Wireless Keys” later)Zn ZT P RC In L010 03 1 10 RF -Enter all zone information except for Loop number, or press “C” to copy the zone information on thisscreen from the last saved zone (including Loop).ZT = Zone TypeP = PartitionRC = Report CodeIn = Input Device TypeL = Loop number to which the sensor is connected.NOTE: Pressing the [C] copies the zone information from the last saved zone which includes theinput type. Verify this information is correct for this zone.On this screen:• Use the [A] key to move to the right.• Use the [B] key to move to left and to back up to “ZT” field.Press [∗] to accept the existing or newly-entered zone information.ZN B M V A C E AD010 − − 1 0 1 1 01Enter the remainder of the zone’s information, or press the [C] key to copy the zone attributes on thisscreen from the last saved zone.B = Not ApplicableM = Not ApplicableV = V-Plex Relay? (only used if “In” = 6)AC = Access Point (only used if ZT = 27, 29 or In = 6,11, 12, 13)E = Entry or Exit? (only used if ZT = 27)AD = Address (only used if “In” = 9)If “In” = 9, enter the Device AddressNOTE: Pressing the [C] copies the zone attributes from the last saved zone. Verify the attributesfor this zone are correct.On this screen:• Use the [A] key to move to the right.• Use the [B] key to move to left and to back up to “V” field.Press [∗] to accept existing information.