Honeywell VISTA-128BPT Programming Manual

Also see for VISTA-128BPT: User guide Overview User guide Installation and setup guide Installation and setup guide

Contents

Honeywell VISTA-128BPT Programming Manual Manual pdf 52 page image

48VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDEPROMPT EXPLANATION010 INPUT S/N: LA XXX-XXXX -If you entered RM, RF, BR, UR or SL for the Input Type, this screen displays. Otherwise the summaryscreen for the next zone displays.Enter the 7-digit serial number, using one of the following methods:a. Transmit two open and close (or close and open) sequences. For a wireless key transmitter, pressand release the button, wait approximately 4 seconds, then press and release the button a secondtime.ORb. Manually enter the 7-digit serial number printed on a label on the transmitter, using the alphakeypad. Then press the [∗] key, the cursor will move to the “L” position. You can edit the loopnumber, if necessary. When the loop number is acceptable, press [∗].ORc. Press key [C] to copy the last serial number enrolled (used when programming a transmitter withseveral input loops).Remember, the [A] key to move to the right, the [B] key to move to the left and, the [#] key to back upwithout saving.010 INPUT S/N: LA022-4064 1Press [∗] to accept the serial number and advance to the “L” position (if method “a” or “c” was used), thenenter the loop number.• If necessary, press the [#] key to back up without saving, and re-enter or edit the serial numberbefore pressing [∗] to save.• The system checks for a duplicate. If a duplicate serial/loop number combination is found, thekeypad will emit a single long beep, and display the serial number along with a “?” for the loopnumber, allowing you to re-enter the correct loop number.010 INPUT S/N: LA000-0000 1To Delete an Existing Serial Number, enter “0” in the loop number field.• The serial number will change to “0”s, pressing [∗] erases the serial number and returns an AXXX-XXXX, indicating it’s ready to enroll the new serial number.• If “0” was entered in error, simply re-enter the loop number or press [#], and the serial number willreturn to the display.XMIT TO CONFIRMPRESS ∗TO SKIPThe prompt to confirm appears. This prompt only appears if you answered “Yes” at the “SET TOCONFIRM?” prompt.• The system enters a confirmation mode so that the operation of the actual programmed input canbe confirmed.• Activate the loop input or button that corresponds to this zone. At any time during this step, youmay press the [∗] key on the keypad to save the serial and loop number combination withoutconfirming.Entd A022-4063 1Rcvd A022-4064If the serial number transmitted does not match the serial number entered, a display similar to theone at the left appears. If the loop number does not match, it also is displayed.• If so, activate the loop input or button on the transmitter once again. If a match is not obtained (i.e.,summary display for the next zone does not appear), press the [#] key twice and then enter ortransmit the correct serial number.• Activate the button on the wireless key again after re-entering the serial number.Zn ZT P RC In L011 00 1 10 00 1If the serial number transmitted matches the serial number entered, the system beeps 3 times andadvances to the summary display for the next zone's programming.After all the zones have been programmed, enter 000 for the zone number to quit.After you have enrolled each wireless device, remove ONE of the serial number labels from that device and affix it inthe appropriate column on the worksheets provided later in this Programming Guide; then enter the otherinformation (zone number, zone type, etc.) relevant to that device.