Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual

Also see for LYNXR-2 Series Security System: User guide Programming guide

Contents

Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual Manual pdf 58 page image

LYNXR-2 Series Installation and Setup Guide- 58 -System OperationSystem DisplaysDisplay MeaningPC Remote Phone Control feature is active (Appears in place of the clock).PH System Speaker Phone mode is active (Appears in place of the clock).AC AC power is present. If not displayed, the system is operating on backup battery power.ALARM System is armed and an intrusion has been detected (also appears during afire alarm or audible emergency alarm). Accompanied by the protection zonethat is in alarm.AWAY All burglary zones, interior and perimeter, are armed.BYPASS One or more burglary protection zones have been bypassed.CHIME Chime feature is activateFAULT A malfunction is discovered in the system; or an open is detected in a fire zone; or afault in a day/night burglary zone is discovered during a disarmed period.Accompanied by a display of the zone number in trouble.FIRE A fire alarm or fire fault is present. Accompanied by a display of the zone thatis in alarmLOW BAT Low battery condition in a wireless sensor (if zone number is displayed) or low systembattery (if no zone number is displayed). If 00 is displayed, a wireless keypad has a lowbattery condition.INSTANT Entry delay is turned off.MESSAGE A message has been recorded and has not yet been played back.REC The system is in Recording mode.STAY Perimeter Burglary zones, such as protected windows and doors, are armedTEST System is in Test mode.ULULULUL Audio alarm verification has not been evaluated by UL.Audio Alarm Verification (Two-Way Voice Feature)This feature allows the central station operator to listen, talk to or conduct a two-way conversation with anindividual(s) at the premises. It also assists the operator in gathering information about the nature andlocation of the alarm that may be helpful in responding to police and fire departments. All LYNXR-2 Seriescontrol panels are capable of supporting the Two-Way Voice feature. The LYNXR-2 Series does not makesystem announcements when the Two-Way voice feature is active.ActivationFire and CO alarms will not trigger an AAV session. A new Fire or CO alarm will end an AAV session that isin progress.The LYNXR-2 Series sends the “alarm message” followed by a “Listen-in-to-Follow message” (Contact ID®code 606) to the Central Station. The Listen-in-to-Follow message causes the Central Station’s digitalreceiver to temporarily hold the phone line for approximately 1-minute. When the LYNXR-2 Series receivesthe “kissoff” from the central station, indicating that the alarm message has been received, the Two-WayVoice (AAV) feature is activated in the (default) “Listen Mode” and sirens and keypad sounds arediscontinued. The LYNXR-2 Series transmits a beep acknowledgment to the Central Station, once persecond. The beep alternates between two tones and indicates that the LYNXR-2 Series is waiting for asession command from the Central Station operator. Once a command is issued the beep acknowledgementis discontinued, however, if a command is not issued within two minutes the system will “time out” and thecall will be terminated.