Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual

Also see for LYNXR-2 Series Security System: User guide Programming guide

Contents

Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual Manual pdf 57 page image

LYNXR-2 Series Installation and Setup Guide- 57 -System OperationRemote Phone Control Keypad FunctionsTo remotely disarm system: + [1]To remotely arm in AWAY mode: + [2]To remotely arm in STAY mode: + [3]To remotely arm in AWAY or STAY with no delay: + [2] or [3] + [0]To remotely activate X10 devices 1-6: [#] + [4] + (2-digit) device no.To remotely activate X10 devices 7 & 8: + [#] + [4] + (2-digit) device no.To remotely deactivate X10 devices 1-6: [#] + [7] + (2-digit) device no.To remotely deactivate X10 devices 7 & 8: + [#] + [7] + (2-digit) device no.To remotely Bypass zones: + [6] + zone no.To remotely activate Forced Bypass: + [6] + [#]To remotely check system status: [✻]To end remote phone control session: Hang Up or enter + [9]Powerline Carrier Devices (e.g. X10 devices)If Powerline Carrier Devices are used, two keypad entries available to the user are included. Theycan manually activate or deactivate the device(s) for starting or stopping some action, such asturning lights on or off, etc.These keypad entries are:Security Code* + [#] + [4] + Device # activates (starts) that device.Security Code* + [#] + [7] + Device # de-activates (stops) that device.*Code is required for devices 7 and 8. Code is not required for devices 1-6.Exit Error Alarm DisplaysThe system will display the following if programmed in Field *59.Display MeaningCA will appear along with a zone indication if an exit or interior zone contained afault during closing at the time the exit delay ended (e.g., exit door left open),but the system was disarmed during the entry delay time. The alarmsounder and keypad sound continuously, but stop when the system is disarmed.No message will be transmitted to the central station.EA will appear along with a zone indication if an exit or interior zone contained afault during closing at the time the exit delay ended, but the system was NOTdisarmed during the entry delay time. The alarm sounder and keypadsound continuously until the system is disarmed (or timeout occurs). An ExitAlarm message is sent to the central station. ORif an alarm from an exit or interior zone occurs within two minutes after theend of an exit delayEntering a second OFF sequence (Code + OFF ) will clear the display.