Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual

Also see for LYNXR-2 Series Security System: User guide Programming guide

Contents

Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual Manual pdf 59 page image

LYNXR-2 Series Installation and Setup Guide- 59 -System OperationOperator CommandsThe Central Station operator begins the session, which last 5 minutes, by entering one of the valid AAVcommands shown in the table below. The session may be extended 5 minutes, without changing theoperating mode, by pressing the [7] key on the touch-tone phone. Selecting another operating mode alsoresets the session an additional 5 minutes. During the last minute of the 5 minute, session, the LYNXR-2Series generates two beeps every 30 seconds to alert the Central Station operator that the session is about totime out. The Central Station operator may then extend the session by pressing the [7] key on the touch-tonephone. If the session is not extended the phone line is disconnected, and the session is ended. Sessions maybe ended at any time by pressing the [9] key on the touch-tone phone. The AAV modes are described asfollows:Note: When entering AAV commands make sure the Central Station receiver has been disconnected from thephone line, otherwise AAV commands may not go through.Key Function1 Talk Mode: Pressing the [1] key on the touch tone phone, enables one-way voice communication from thecentral station to the violated premises, and allows the operator to talk communicate through the LYNXR-2Series speaker. In this mode the ARMED (red) and READY (green) LEDs blink alternately.2 VOX (Voice) Mode: Pressing the [2] key on the touch-tone phone, enables two-way voice communicationsbetween the central station and the violated premises. In this mode the ARMED (red) and READY (green)LEDs blink alternately.3 Listen Mode: Pressing the [3] key on the touch-tone phone, enables one-way audio from the violated premisesto the central station. The Listen Mode is the start up default mode of the voice feature and allows theoperator to listen through the LYNXR-2 Series microphone. This mode does not affect the existing LEDpattern.7 Extends the session 5 minutes without changing its operating mode.9 Ends the session and disconnects the phone line.