Honeywell LYNXR-2 Programming Manual

Also see for LYNXR-2 Series Security System: Installation and setup guide User guide

Contents

Honeywell LYNXR-2 Programming Manual Manual pdf 2 page image

- 2 -TABLE OF CONTENTSData Fields ................................................................................................................................................................3✻56 Enhanced Zone Programming........................................................................................................................11✻80 Device Programming.......................................................................................................................................13✻81 Zone Lists ........................................................................................................................................................14✻83 Enhanced Sequential Mode ...........................................................................................................................15✻84 Assign Zone Voice Descriptors .......................................................................................................................16Vocabulary Index (for ✻84 Assign Zone Voice Descriptors) ..................................................................................16✻85 Record Custom Voice Descriptors..................................................................................................................18✻56 Enhanced Zone Programming Worksheet......................................................................................................18Powerline Carrier Device Worksheet for ✻80 and ✻81...........................................................................................205800 Series Transmitter Loop Numbers Diagram ..................................................................................................21Special Messages...................................................................................................................................................22LYNXR-2 Summary of Connections Diagram .........................................................................................................23Refer to the Installation and Setup Guide for detailed information on programming the LYNXR-2 system. TheInstallation and Setup Guide includes full descriptions of all data fields.UL LYNXR-2 is not intended for UL985 Household Fire applications unless a 24-hour backup battery(P/N LYNXRCHKIT-HC or LYNXRCHKIT-SHA) is installed.TO ENTER PROGRAMMING MODE:1. Power up, then depress [✻✻✻✻] and [#] both at once, within 50 seconds of powering up.OR2. For factory defaulted system, enter: Installer Code (4 + 1 + 1 + 2) plus 8 + 0 + 0. ORIf different Installer Code is programmed, enter: New Installer Code + 8 + 0 + 0.(if ✻98 was used to exit previously, method 1 above must be used to enter the program mode again)3. Upon entry into Program mode, data field ✻20 will be displayed (the first data field in the system) and bothkeypad LEDs will flash.TO PROGRAM THE DATA FIELDS:1. Press [✻] followed by the desired field number (e.g., ✻21), then make the required entry.2. The keypad beeps three times after entering data, then displays the next data field in sequence.3. For phone number and account number fields, press [✻] to end the entry if less than number maximumnumber of digits is entered.4. To delete an entry, simply press [✻] plus that field number and reenter the correct data. For phone numberand account number fields ✻40-✻44, ✻88 and ✻94, press [✻] + field number + [✻].INTERACTIVE MENU MODES:There are six interactive menu modes as listed below. To enter these modes, first enter Program mode. While inProgram mode, press [✻] plus the mode number desired (e.g., ✻56).✻56 Enhanced Zone Programming ...............For programming zone characteristics, report codes, etc.✻80 Device Programming..............................For programming Powerline Carrier Devices✻81 Zone List Programming ..........................For programming zone lists for use with Powerline Carrier Devices✻83 Enhanced Sequential Mode ...................For entering transmitter serial numbers✻84 Assign Zone Voice Descriptors ..............For assigning voice descriptors to zones✻85 Record Custom Voice Descriptors .........For recording custom voice descriptors