Honeywell LYNX Touch SIA Manual

Contents

Honeywell LYNX Touch SIA Manual Manual pdf 3 page image

- 3 -Entering Programming ModeYou may find it convenient to adjust the volume setting before entering the Programming Mode. Thiswill allow you to clearly hear feedback announcements or system beeps.1. Power up the LYNX Touch SIA control, when the Home Screen appears, select “More”.2. Select “Tools”. The system displays a virtual keypad.3. Enter: Installer Code (4 + 1 + 1 + 2).4. The System Programming Screen is displayed. Select “Program”. The Armed and Ready LEDs will flash andthe following options will be displayed:Installer CodeDate TimeZonesKeysSystem TypeCommunicatorComm. DiagnosticsReporterUse the down T arrow to scroll to the next page of options.SounderDefault Config.Reset Master CodeSystem SettingsLanguage*Z-Wave* This field may not be applicable to the system being installed.5. Select an option to advance to that Programming screen.Note: If a different Installer Code has been programmed, enter: the New Installer Code.Programming the Data Fields1. Select each desired programming option, and then select the required entry. The system beeps each time aselection is made.2. The system will toggle or scroll through the options or display a new screen as required for the specificoption.3. To delete or change an entry, simply select the desired option, and then select the required entry.Loading a Default Set:1. Enter the Installer Programming Mode and advance to second page of the System Programming.2. Select ‘Default Config’ and select the appropriate Default Table Configuration from the following options orSelect Default Downloader to reset all subscriber account numbers and CSID in preparation for an initialdownload:Default Config 1Default Config 2Default Config 3Default Config 4Default DownloaderNote: Refer to the Programming Default Tables section of this manual to view the default values.Exiting Programming Mode:1. Select the “2” key to exit the current screen. The system returns to the previous screen.2. Select the “2” key as required until system displays a Confirmation screen.3. Select “Yes” to allow the installer to re-enter Programming mode or “No” to prevent re-entry. If “No” isselected, you can still re-enter Program Mode by powering down the unit (remove AC and battery power) andentering Program Mode within 30 seconds of powering up.4. Select the “2” key again to return to the Home Screen.