Honeywell Galaxy 18Galaxy Programming Manual

Also see for Galaxy 128: User guide User guide User guide

Contents

Honeywell Galaxy 18Galaxy Programming Manual Manual pdf 167 page image

Galaxy Programming Manual16116 CHECK ZONESA=VIEWOption 66 – Pre-checks (Galaxy 60, 128, 500, 504 & 512)The Pre-Check option provides added system security by alerting the user to zones that may not be operatingcorrectly.NOTE: Pre-check does not operate when the system is in the engineer mode.Testing ZonesThe Entry/Exit Horns beep once when each zone is tested. As each zone is successfully tested, the keypadindicates the number that remain to be tested. When the last zone is successfully tested the Entry/Exit Hornsounds twice and the keypad displays 0 CHECK ZONES; press the ent key to resume the system routine.1 = ModeThe Mode determines the pre-check level that the selected zones are subjected to before the system can set.The Mode is selected from one of the following:1. Disabled (default): the pre-check option is disabled; even if zones are selected, they are not checked.2. Warning: when the setting routine is started the user is informed of the number of selected pre-checkzones that have not been activated since the system was unset; press the A or B keys to view the zones.Press the ent key to continue the setting routine. The zone that have not been activated do not have to betested.3. Autocheck: when the setting routine is started the user is informed of the number of selected pre-checkzones that have not been activated since the system was unset and a warning is sounded; press the A or Bkeys to view the zones. These zones must be tested before setting can be resumed.4. Forced Check: when the setting routine is started the keypad indicates the number of pre-check zonesthat are on the system; to view the pre-check zone addresses press the A or B keys. All of the pre-selected zones must be tested before setting can take place.2 = Select ZonesOn selecting 2 = Select Zones, the address and function of the first zone on the system is displayed. Move tothe required zone by pressing the A or B keys or by entering the zone address. To toggle the status of the pre-check attribute of the zone press the # key; the keypad indicates that the zone is included in the pre-check bydisplaying PRE-CHECK ZONE. Select other zones to be pre-checked in the same way. Once all of thezones have been selected, press the esc key.0 CHECK ZONESENT=SET66 - Pre-Check