Hasselblad H2F User Manual

Also see for H2F -: Datasheet User manual

Contents

Hasselblad H2F User Manual Manual pdf 19 page image

19171619181514Protective base plate 18, 19To attach the protective base plate, slip it over the camera footuntil it stops. To remove it, lift the securing catch while pushingthe plate back as in the illustration.PC-connectorA PC connector for non TTL-flash synchronisation is located onthe left side of the body. It is protected by a captive rubber plug.Accessory connection 16, 17On the left hand side of the camera body are two accessory retain-ing screw threads (M5), as well as a databus connector, protectedbeneath a cover. The connection has a dual-function, for servicepurposes and accessories such as the Global Image Locator.The cover can be removed by inserting a pointed object, such asa pen, in the small hole and then sliding it to the left, as in the il-lustration. The retaining clip can then also be removed to accessthe connector. Do not attempt to clean the screen by immersing it in water, oruse any kind of cleaning fluid. If the screen becomes damp, do notuse hot air to dry it. Use a soft cloth on the upper surface only. Seekadvice from an Authorized Hasselblad Service Center if the screenbecomes particularly soiled. Remember that particles or greasymarks on the screen might impair the viewfinder image but haveno effect whatsoever on the recorded image.Viewfinder screen 14, 15, 16The H2F is fitted with a Spherical Acute-Matte D viewfinder screenfor extreme brightness, clarity and even illumination. An optionalaccessory screen with a grid pattern is also available.To change a viewfinder screen, remove the viewfinder to accessthe viewfinder screen. To remove the screen, place the tip of aballpoint pen or similar in the viewfinder screen removal lug andpull upwards. To replace the screen, position the right side of thescreen in place so that it sits correctly in the recess. Place the tipof a ballpoint pen or similar in the viewfinder screen replacementindentation and press downwards until the screen snaps intoposition. Try to avoid touching either surface of the screen withbare fingers.