Handspring Treo 180 User Manual

Also see for Treo 180: Features User guide User guide Battery installation instructions

Contents

Handspring Treo 180 User Manual Manual pdf 24 page image

Page 24 Introduction to Your Treo™ 180 CommunicatorConnecting the HotSync cableThe HotSync cable that comes with your Treo enables you to charge your communicator batteryand to synchronize the information on your communicator using HotSync technology.To connect the HotSync cable:1. Connect the travel charger cable to the short end of the Hotsync cable. Be sure to match thesides of the connectors labeled “UP.”2. Connect the USB HotSync cable to a USB port on your computer.3. Connect the long end of the HotSync cable to your communicator with the button facing up.NNNNooootttteeee:::: If you are unsure about the exact location of the USB port on your computer, refer to themanual supplied with the computer.4. Plug the travel charger into a wall outlet.TTTTiiiipppp:::: The travel charger does not need to be plugged into a wall outlet to perform a HotSyncoperation. However, if you want to use the HotSync cable to charge your Treocommunicator, you must plug the travel charger into a wall outlet.USB cable and port