HP xw8400 Install Manual

Also see for xw series: Troubleshooting guide Installation guide Installation guide Installation guide Installation guide

Contents

kit contents

SAS rear panel cable installation5/12Optional SAS mounting bracket installation1. Identify an unused PCI slot. Depress the PCI retention clamp clips and lift the retention clamp 1.Remove the PCI slot cover from the PCI slot 2.Figure 4 Remove PCI slot cover2. Attach the MiniSAS 4X connector of the SAS rear panel cable assembly to the SAS mounting bracket1. Install the SAS mounting bracket in the workstation in place of the PCI slot cover 2. Connect theSAS cables to the SAS connectors on the system board 3, or to an approved, compatible plug in card.(Refer to Before you begin in this document for information on approved, compatible cards.)Figure 5 Attach SAS rear panel cable assembly to workstation