HP xw8400 Install Manual

Also see for xw series: Troubleshooting guide Installation guide Installation guide Installation guide Installation guide

Contents

kit contents

Page 1 of 2SAS Rear Panel Cable InstallationSAS Rear Panel CableHP xw Series WorkstationsThis document describes how to install the Serial Attached SCSI (SAS) rear panel cable for your HPWorkstation.Kit ContentsThis kit includes the following components:■ SAS rear panel cable with mounting screw■ SAS rear panel cable instruction (this document)■ WarrantyObserve Warnings and CautionsÅ WARNING: Any surface or area of the equipment marked with this symbol indicates the presences of ahot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk ofinjury from a hot component, allow the surface to cool before touching.Å WARNING: Any surface or area of the equipment marked with this symbol indicates the presence of anelectrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area.Ä CAUTION: Static electricity can damage the electronic components of the workstation. Before beginningthese procedures, be sure you are discharged of static electricity by briefly touching a grounded metalobject.Step 1—Prepare the WorkstationYour workstation documentation includes instructions for disassembling and preparing the workstation forinstallation, including shutting down power, disconnecting all power from the system, and removing theaccess panel. For more detailed information, refer to the Service and Technical Reference Guide for yourHP Workstation at http://www.hp.com/support/workstation_manuals.

/ 2

Related manuals for HP xw series