Installation InstructionsHP Retail Integrated2x20 DisplayCopyright © 2014 Hewlett-Packard Development Company, L.P. Theinformation contained herein is subject to change without notice.Printed inFirst Edition: April 2014*765300-001*765300-001NOTE: Refer to the HP L6015tm and L6017tm Retail Touch MonitorsUser Guide, the HP RP7 Retail System Model 7800 HardwareReference Guide, the HP RP7 Retail System Model 7100 HardwareReference Guide, or the HP RP2 Retail System Hardware ReferenceGuide at www.hp.com for detailed instructions on installing USBmodules.Before You BeginBefore installing the 2x20 display, be sure to power off the system anddisconnect the power cord from the power outlet.WARNING! To avoid the risk of serious injury or damage to thesystem, ensure that the power cord is unplugged from the electricaloutlet at the wall before installing the 2x20 display. Failure to do somay expose you to the risk of electric shock.NOTE: For regulatory and safety notices, refer to the ProductNotices included with your product.Configuring the DisplayTo configure the 2x20 display, refer to the HP Point of Sale ConfigurationGuide (available in English only). The guide is located with thedocumentation on your retail computer and at www.hp.com. To accessthe guide on the retail computer:• In Microsoft Windows XP or Windows Embedded POSReady 2009,select Start > All Programs > HP Point of Sale Information.• In Microsoft Windows 7, Windows Embedded POSReady 7, Windows8.x, or Industry 8.1, select Start > HP Point of Sale Information.Check www.hp.com/support for updated software or documentation thatbecame available between the time your product was manufactured anddelivered to you.L6015tmL6017tmRP7 7800RP7 7100HP L6015tm and L6017tm Retail Touch MonitorsNOTE: Inserting the screws is arequired step.HP RP7 Retail System Model 7800NOTE: Inserting the screws is arequired step.RP2 2000RP2 2030NOTE: This step may not be necessaryif a connector cover is not installed inthe USB port.