HP Integrity rx1600 Deployment Manual

Also see for Integrity rx1600: Limited warranty Firmware update guide Limited warranty Cable Routing guide Installation guide

Contents

Sectors = 32StripeSize = 256ArrayAccelerator = Enabled; HBA SSP SpecificationsHBA_WW_ID= 10000000C9272B34ConnectionName= TestConnHostMode= LinuxTable 6-5 cpqacuxe OptionsDescriptionOptionSpecifies the capture file. The capture filename is optional. If no capture file is specified,the default capture file is acucapt.ini in the ACU working directory.-C FILENAMESpecifies the error file. The error filename is optional. If no error file is specified, thedefault error file is error.ini in the ACU working directory.-E FILENAMELimits the capture to internal controllers.–internalLimits the capture to external controllers.–externalDisplays help information.-hThe cpqacuxe UtilityThe cpqacuxe utility uses a text file that contains options and parameters required to configurearray controllers. Lines of the script file can be blank or in the form option = value. Thecpqacuxe utility parses the file in a case-insensitive manner. Semicolons are used for commentswithin script files. If the first character in the line is a semicolon, the line is a comment and thecpqacuxe utility ignores everything up to the next line. The valid options in script files generatedand read by the ACU utility are divided into the following categories:• Control options— Define the overall behavior of the cpqacuxe utility when it processesthe scripts and stamps configurations. Control options can occur only once in the script fileand must be the first options in the file.• Controller options— Define a controller or set of controllers used in the configuration. Thisset of options must start with the Controller option. All other options up to the next Controlleroption are assumed to belong to the controller that is being defined. These options can bespecified in any order, but an option from another category of options cannot occur betweenany two options in this category.• Array options— Specify and describe a particular array in the configuration. These optionsare invalid if there is not a preceding controller option section. This set of options must startwith the Array option, and all the following options up to the next Array or Controller optionare assumed to belong to the array being defined. These options can be specified in anyorder, but an option from another category of options cannot occur between any two optionsin this category.• Logical drive options— Specify and describe a particular logical drive in the configuration.These options are invalid if there is no preceding array option. This set of options must startwith the LogicalDrive option, and all the following options up to the next LogicalDrive,Array, or Controller option are assumed to belong to the logical drive being defined. Theseoptions can be specified in any order, but an option from another category of options cannotoccur between any two options from this category. In general, Logical Drives must be listedin the input file in increasing order, unless existing drives are being reconfigured withoutdata loss.• HBA options— Specify and describe a Host Bus Adapter (HBA) SSP configuration. Theseoptions are invalid if there are no preceding logical drive options. This set of options muststart with the HBA_WW_ID option, and all the following options up to the next LogicalDrive,Array, Controller, or HBA_WW_ID option are assumed to belong to the HBA being defined.cpqacuxe 53