-250Figure 197: Y home sensor mounting screw location4. Remove the Y home sensor.Installing the Y Home Sensor1. Align the Y Home Sensor with the mounting hole.2. Using a 1⁄4 ” nut driver or standard screwdriver, reinstall the mountingscrew.3. Reconnect the Y Home cable.4. Install the top panel. See “Installing the top panel” on page 162Y EOT (End of Travel) SensorRequired Tools• 1⁄4 ” nut driver or standard screwdriver.Hardware• 6-32 x 3⁄8 ” slotted screw (x1)Removing the Y EOT sensor1. Remove the top panel. See “Removing the top panel” on page 1612. Disconnect the Y EOT cable by pressing in on the tab and pulling out-ward. See Figure 198.Remove themounting screw
