HP 10GbE Pass-Thru Module User Manual

Also see for 10GbE Pass-Thru Module: Quickspecs

Electrostatic discharge 30Electrostatic dischargePreventing electrostatic dischargeTo prevent damaging the system, be aware of the precautions you need to follow when setting up thesystem or handling parts. A discharge of static electricity from a finger or other conductor may damagesystem boards or other static-sensitive devices. This type of damage may reduce the life expectancy of thedevice.To prevent electrostatic damage:• Avoid hand contact by transporting and storing products in static-safe containers.• Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.• Place parts on a grounded surface before removing them from their containers.• Avoid touching pins, leads, or circuitry.• Always be properly grounded when touching a static-sensitive component or assembly.Grounding methods to prevent electrostaticdischargeSeveral methods are used for grounding. Use one or more of the following methods when handling orinstalling electrostatic-sensitive parts:• Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wriststraps are flexible straps with a minimum of 1 megohm ±10 percent resistance in the ground cords.To provide proper ground, wear the strap snug against the skin.• Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both feetwhen standing on conductive floors or dissipating floor mats.• Use conductive field service tools.• Use a portable field service kit with a folding static-dissipating work mat.If you do not have any of the suggested equipment for proper grounding, have an authorized resellerinstall the part.For more information on static electricity or assistance with product installation, contact an authorizedreseller.Get other manuals https://www.bkmanuals.com