47[Sysname-nqa-admin-test] type udp-jitter[Sysname-nqa-admin-test-udp-jitter] reaction 2 checked-element jitter-ds threshold-typeaccumulate 100 threshold-value 50 5 action-type trap-onlyreaction checked-element mosUse reaction checked-element mos to configure a reaction entry for monitoring the MOS value in theNQA operation. You cannot edit a reaction entry. To change the attributes in a reaction entry, use undoreaction to delete the entry first and then configure a new one.Use undo reaction to delete the specified reaction entry.Syntaxreaction item-number checked-element mos threshold-value upper-threshold lower-threshold[ action-type { none | trap-only } ]undo reaction item-numberDefaultNo reaction entry for monitoring the MOS value is configured.ViewsVoice operation viewDefault command level2: System levelParametersitem-number: Specifies a reaction entry ID in the range of 1 to 10.threshold-value: Specifies threshold values.upper-threshold: Specifies the upper threshold in the range of 1 to 500.lower-threshold: Specifies the lower threshold in the range of 1 to 500. It must not be greater than theupper threshold.action-type: Specifies what action to be triggered. The default action is none.none: Specifies the action of only displaying results on the terminal display.trap-only: Specifies the action of displaying results on the terminal display and meanwhile sendingSNMP trap messages to the NMS.Usage guidelinesFor the MOS threshold, the number is expressed in three digits representing ones, tenths, and hundredths.For example, to express a MOS threshold of 1, enter 100.Examples# Create reaction entry 1 for monitoring the MOS value of the voice operation. Set the upper thresholdto 2, and lower threshold to 1. Before the NQA operation starts, the initial state of the reaction entry isinvalid. After the operation, the MOS value is checked. If it exceeds the upper threshold, the state of thereaction entry is set to over-threshold. If it is below the lower threshold, the state is set to below-threshold.Once the state of the reaction entry changes, a trap message is generated and sent to the NMS. system-view[Sysname] nqa entry admin test[Sysname-nqa-admin-test] type voice
