Gateway SX2885 User Manual

Gateway SX2885 User Manual Manual pdf 17 page image

Using your computer - 17Connect a monitorTo connect a monitor, simply plug the monitor cable into the appropriateport located on the rear panel of your computer.Note: The type of connection can vary. Use a cable that matches bothyour monitor and your computer. Refer to the monitor manual foradditional instructions and information.Connect to a broadband networkIndividual network configurationConnect one end of the network cable on the network port on the rear ofthe computer, then connect the other end of the network cable into thecable modem or network jack or hub on your network.Note: Consult your operating system help files for information on howto configure your network setup.Connect to power1. Plug the power cable into the power cable socket located on the rearpanel of your computer.2. Plug the other end of the power cable into a power outlet.Caution: Before you proceed, check the voltage range in yourarea. Make sure that it matches your computer's voltage setting.If they don't match, change your computer's voltage settingaccording to your area's voltage range.