Gateway GT5448E - GT - 2 GB RAM Reference Manual

Also see for GT5436E: Setting up

Contents

Gateway GT5448E - GT - 2 GB RAM Reference Manual Manual pdf 43 page image

www.gateway.com37Adding or replacing a CD orDVD driveTo add replace a CD or DVD drive:1 Remove the side panel by following the instructions in“Removing the side panel” on page 31.2 Remove the front bezel by following the instructions in“Removing the front bezel” on page 32.3 If you are installing a new drive (not replacing an oldone), remove the two drive retention screws in the drivebay, then go to Step 7. For the location of the screws,see the photo in Step 6.4 If you are replacing an existing drive, disconnect thecables from the drive, noting their locations andorientation. You will reconnect the cables after youinstall the new drive. (CD/DVD drive shown.)5 Note any jumper settings on the old drive and set thejumper on the new drive to be the same.ToolsYou need a Phillips screwdriver to add or replace a CD or DVD drive.ImportantThe color and shape of your replacement drive’s front cover mayvary from your original drive.