GarrettCom DS60s Installation And User Manual

GarrettCom DS60s Installation And User Manual Manual pdf 13 page image

Magnum DS50 / DS60s Dual Speed Hubs Installation and User Guide (06/02)five shared 10/100Mb RJ-45 ports and one “10/100Mb switched RJ-45 port. There is an up-link(UPLINK) switch for Port 1. There is a manual switch “FF-A” underneath the switched port #6that controls and provides “full-fixed” and “Auto-negotiation” capability to the port.2.2.4 Port #6: Switched 10/100 Mb/s Port for DS60C onlyFor Magnum DS60CDual-speed Hub plus has Port 6 as aswitched port located on the rightfront panel. Because of its dualspeed and auto negotiationcapability, it operates either as a10BASE-T port or as a 100BASE-TX port. The speed may dependupon the attached unit’s speed. See section 4.3 for more details about the 10 or 100 switch.FF-AManual SwitchFigure 2.2.3: Port 6: Switched 10 or100Mb PortLink LEDRX LED6RXFDX100LKFF-A100 LEDFDXThis switched port offers great flexibility in connecting the DS60C . . . as anadditional 10/100Mb segment . . . to an existing 10 or 100Mb network. Because this port issegmented from the other DS60C ports, it provides a separate collision domain. Accordingly,the DS60C can be used as plug-and-play in practically any 10Mb or 100Mb network domain.The Magnum DS60C has power (PWR) and collision (COL) LED’s and 10 and 100LED’s for the unit. It also has link (LINK) and receive (RX) activity LED’s for each of thefive shared ports and for Port 6. The port #6 has Full-duplex (FDX) and speed (100) LED’s too.Rubber feet on the bottom provide a sturdy grip and clearance for the exhaust of the coolingfan.The internal power supply is an auto ranging AC power input of 115-230 vac, 50/60Hz. The recessed male IEC power connector is located at the right-rear. Two mountingbrackets for optional wall mounting are supplied with each unit. An optional “edge- stand” isavailable (See “Spare Parts Price List”) and is used for floor-mounting on carpeted surfaces.2.2.5 Magnum DS50 Dual-speed Hubs ChassisThe Magnum DS50 chassis houses one main board for the five dual-speed repeaterports. It has an internal power supply and a small cooling fan in the bottom. The front side ofchassis consists of five shared 10/100Mb RJ-45 ports. There is an up-link (UPLINK) switchnext to Port # 1, which it controls.9www GarrettCom com. .