Garmin GPS V Reference Manual

Also see for GPS V: Specifications Specification Owner's manual and reference guide

Contents

Garmin GPS V Reference Manual Manual pdf 80 page image

70Appendix A The GPS V can be connected to a PC, beacon receiver, marine autopilot or othercompatible device using the supplied PC Interface Cable with RS-232 Serial Port Con-nector (P/N 010-10141-00).The GPS V can be connected to a vehicle’s electrical system and a PC, beaconreceiver, marine autopilot, or other compatible device using the optional PC InterfaceCable with Cigarette Lighter Adapter (P/N 010-10165-00).The GPS V may be hard-wired to the vehicle’s electrical system (10-32 VDC) and aPC, beacon receiver, marine autopilot or other compatible device using the Power/DataCable with bare wire leads (P/N 010-10082-00).WARNING: The terms of the Garmin Warranty require that the Power/DataCable with bare wire leads be installed by experienced installers at a quali-fi ed installation facility, (i.e. electrical accessory installation center, auto,or marine dealer service center). The user should not attempt installationwithout proper knowledge of automotive or marine electrical systems andskill in the use of special tools or hardware required for installation.Consult the wiring diagrams at the side and bottom of the page for proper connec-tions. (The male connector on the back of the GPS V and wiring leads are illustrated tothe right, wiring lead color coding is illustrated below.)Wiring/Interfacing(-) GroundData OutData In(+) PowerPower and Data Connections from the backof the unit.To remove the attached antenna for connec-tion to a remote antenna: rotate to a 45°angle and gently pull away from the unit.The antenna port accepts a standard BNCconnector. 10-35 VDC