2-24Garmin G500H Pilot’s Guide 190-01150-02 Rev. JForewordSec 1SystemSec 2PFDSec 3MFDSec 4HazardAvoidanceSec 5AdditionalFeaturesSec 6Annun.& AlertsSec 7SymbolsSec 8GlossaryAppendix AAppendix BIndexExample of activating Auto-Slewing in the G500H:Course Pointer slewedto 312° for the ILSFigure 2-30 Auto-Slewing HSI with ILS Loaded and Shown with the CorrespondingApproach Plate1) The aircraft is flying vectors to final on an active ILS approach, with theappropriate approach in the GPS navigator.2) The appropriate ILS frequency must be activate in the navigator.3) Verify that the waypoints for the approach are displayed on the Nav Map Pageor the FPL Page of the MFD.4) Upon approaching the final course, select LOC on the HSI.NOTE: If auto CDI switching is active on the GPS unit, the GPS will forcethe GPS/GDU 620 to NAV when the aircraft is close to the LOC course.5) The CDI and course pointer will change from magenta to green and the pointerwill move, or slew, to the final approach course (or 180° from the final approachcourse for LOC BC approaches).