Garmin DriveSmart 50 Owner's Manual

Also see for DriveLuxe 50: Owner's manual

Garmin DriveSmart 50 Owner's Manual Manual pdf 6 page image

Garmin DriveSmart 60 Device OverviewÀ Power keyÁ Mini-USB power and data portÂ Map and data memory card slotÃ Microphone for Voice Command or hands-free callingGarmin DriveSmart 70 Device OverviewÀ Power keyÁ Mini-USB power and data portÂ Map and data memory card slotÃ Microphone for Voice Command or hands-free callingConnecting the Device to Vehicle PowerWARNINGThis product contains a lithium-ion battery. To prevent thepossibility of personal injury or product damage caused bybattery exposure to extreme heat, store the device out of directsunlight.Before you use your device on battery power, you should chargeit.1 Plug the vehicle power cable À into the USB port on thedevice.2 Press the mount Á onto the suction cup Â until it snaps intoplace.3 Press the suction cup to the windshield, and flip the lever Ãback toward the windshield.4 Fit the tab on the top of the mount into the slot on the back ofthe device.5 Press the bottom of the mount into the device until it clicks.6 Plug the other end of the vehicle power cable into a poweroutlet in your vehicle.Turning the Device On or Off• To turn the device on, press the power key, or connect thedevice to power.• To put the device in power saving mode, press the power keywhile the device is on.While in power saving mode, the screen is off and the deviceuses very little power, but it can wake instantly for use.TIP: You can charge your device faster by putting it in powersaving mode while charging the battery.• To turn off the device completely, hold the power key until aprompt appears on the screen, and select Off.The prompt appears after five seconds. If you release thepower key before the prompt appears, the device enterspower saving mode.Acquiring GPS SignalsWhen you turn on your navigation device, the GPS receivermust collect satellite data and establish the current location.in the status bar indicates the satellite signal strength. The timerequired to acquire satellite signals varies based on severalfactors, including how far you are from the location where youlast used your navigation device, whether you have a clear viewof the sky, and how long it has been since you last used yournavigation device. The first time you turn on your navigationdevice, it may take several minutes to acquire satellite signals.1 Turn on the device.2 Wait while the device locates satellites.3 If necessary, go outdoors to an open area, away from tallbuildings and trees.When turns green, the device has acquired satellite signalsand is ready for navigation.Status Bar IconsThe status bar is located at the top of the main menu. The statusbar icons display information about features on the device. Youcan select some icons to change settings or view additionalinformation.GPS signal status. Hold to view GPS accuracy and acquiredsatellite information (Viewing GPS Signal Status, page 19).Bluetooth®technology status. Select to view the Bluetoothsettings (Bluetooth Settings, page 17).Connected to hands-free calling. Select to place a phone call(Hands-Free Calling, page 14).2 Getting Started