9GBStorage /Overwintering :Disposal :(in accordance withRL 2002 / 96 / EC)Set switching point of SoilMoisture Sensor :Display soil moisture :Usage :Increase soil moisture level :v If the soil seems too dry for an application (type of soil or plantspecies), turn the switching controller H to the right towards“Damp” (e.g. with a coin).Reduce soil moisture level :v If the soil seems too damp for an application (type of soil orplant species), turn the switching controller H to the lefttowards “Dry” (e.g. with a coin).The soil moisture can be displayed at any time with the SoilMoisture Sensor. When the Soil Moisture Sensor shows“Damp” K, watering is not carried out.v Press indicator button I.The soil moisture value last measured is indicated for 1 minutewith the relevant LED ( “Dry” Jor “Damp” K).During the minute in which the measured result is displayed, theswitching controller can be used to find the relevant switchingpoint by turning the switching controller until the display changesfrom “Dry” J to “Damp” K or vice versa. If the display doesnot change, the ground is either very dry or very damp.To keep the soil moisture level as constant as possible, irrigationshould be carried out with short watering cycles and shortwatering times. This especially applies to flower boxes onbalconies, which have a watering time of < 5 min.6. Putting into StorageThe storage location must not be accessible to children.1. Remove batteries from the Soil Moisture Sensor and WaterTimer.2. Store Water Timer and Soil Moisture Sensor in a dry placeprotected from frost.Important !Return spent batteries to one of the sales outlets or dispose ofbatteries via your municipal recycling collection centre.Only dispose of battery once discharged.The product must not be added to normal household waste. Itmust be disposed of in line with local environmental regulations.v Important: Make sure that the unit is disposed of via yourmunicipal recycling collection centre.HJ KHJ KI1835-28.960.02_12.03.2007.qxd 15.03.2007 15:38 Seite 9