Gaggenau RW 464 Installation Instruction

Also see for RF 411: Installation instruction Installation instruction Installation instructions Installation instructions Installation instruction

Contents

Gaggenau RW 464 Installation Instruction Manual pdf 13 page image

132. Attaching alternative anti-tilt deviceImportant note:If the anti-tilt brackets cannot be securely attached,a wooden beam can be used above the appliance as analternative anti-tilt device. Care should be taken that thereis not a gap between the appliance and the wooden beam.As far as possible, always screw the wooden plank to therear wall of the niche.1. Cut the wooden plank to the required length (crosssection min. 8 x 10 cm). The length should correspondto the width of the installation niche!Notes:– If the installation niche is deeper than the appliance,select a stronger beam or use two, one behind theother.– The plank must overlap the appliance by at least50 mm.2. Mark the installation height (underside edge of theplank) on the rear wall of the niche.3. Select the screws according to the thickness of thewooden plank: Length min. 2.5 x wood thickness,diameter 12 or 14 mm.Note:Select the number of screws corresponding to theniche width so that you ensure that the plank can besecurely mounted.According to the subsurface:4. Look for the supports on the rear wall of the niche andmark the drill holes on the plank corresponding to theposition of the support.or5. Fasten suitable dowel into the rear wall.6. Pre-drill.7. Screw the plank onto the rear wall of the niche.3. Attaching the edge protectorsTo protect the edges of the installation cavity, it isrecommended to attach edge protection made ofa suitable material.Attach the edge protection with the adhesive tape whichwas used to attach the accessories to the appliance.4. Attaching the fastening sheets(lateral)Attach the fastening sheets (lateral) to the appliance.These are special installation steps.Instructions are provided after section D.– Exchanging the door hinges see“Changing over the door hinges”.– Sealing mat, see “Removing/changingthe sealing mat”.– Side-by-Side set up see “Side-by-Sideset up”.– Water connection see “Preparing thewater connection”.