Gaggenau RW 464 Installation Instruction

Also see for RF 411: Installation instruction Installation instruction Installation instructions Installation instructions Installation instruction

Contents

Gaggenau RW 464 Installation Instruction Manual pdf 10 page image

10Installation manualThe following mounting instructions describe mountingsteps for various appliance models.Therefore, deviations may occur from that shown in thediagrams.Reference is made to specific mounting steps for individualappliances.1. Check the installation nicheã Caution:Before starting the installation, check carefully thatthe installation cavity meets the require-ments fora secure and trouble-free installation:1. Check the subsurface.Follow the notes in the section “Installing theappliance”.2. Check the dimensions of the niche.3. Re-examine whether the niche has right angles.4. Re-examine the positioning of the plug.Additionally follow the instructions in the sections“Electrical connection” and “Dimensions of theinstallation niche”.5. Check the positioning of the water connection(for appliances with ice maker)Additionally follow the instructions in the sections“Water connection” and “Dimensions of the installationniche”.6. Re-examine the stability and fastening of theneighbouring cabinet parts. All cabinet parts in thevicinity of the appliance have to be firmly connected tothe wall.7. Re-examine that when opening the appliance door,it does not collide with neighbouring kitchen parts(for door opening angle).2. Removing the packagingã Warning:– The appliance could tip over when unpacking.– The appliance could tip over when the appliancedoor is opened.– The appliance is very heavy.Risk of personal injury and damage to the appliance!Note:Check the appliance for damage. Do not install theappliance if there is visible damage. If there are queries,please contact the dealer.To protect the subsurface from damage whilst installing:1. Place cardboard or plywood under the appliance.2. Remove packaging carton. Be careful when using theknife so as not to damage the surface of the appliance.3. Remove accessories from the outside of theappliance.Keep adhesive tape which was used to attach thesupplied accessories to the appliance. It isused subsequently for attaching the edge protectionto the cavity walls (see Section“B / 1. Sliding the appliance into the installationniche”).4. Remove transportation protection devices (a) and liftappliance off the pallet – appliance is very heavy!5. Carefully open the appliance – risk of tipping over –and remove accessories and installation materials frominside the appliance. Close the door again.Note:Only remove the transporting securing units with whichthe slide-in bases and the storage compartments inthe appliance are protected after completing theinstallation as otherwise, parts could be damaged.